Installation Procedure
99
E-mail
11
5) Enter an e-mail address using the keyboard displayed.
6) Select [Save].
7) Set a host name and a domain name as above.
8) Select [Close].
If [SMTP] has been selected for [Mail Receive Protocol]
Aliases cannot be configured. A user can decide an account name (the left side of the
@ mark). An address (the right side of the@ mark) is a combination of a host name and
a domain name.
Example: mymail@myhost.example.com
z
Account name : mymail
z
Host name : myhost
z
Domain name : example.com
If [POP3] has been selected for [Mail Receive Protocol]
Specify a POP user name to an account name (the left side of the @ mark), and a mail
server to an address (the right side of the @ mark). A user can decide an alias such as
mymail@example.com.
Example: mymail@mb1.abc.example.com
z
Account name : mymail
3
Set the protocol for receiving e-mail.
1) Select [Other Settings].
2) Select [E-mail Receive Protocol] and then select [Change Settings].
3) Select either [SMTP] or [POP3] as appropriate for your environment.
4) Select [Save] and then press [Close].
If [SMTP] has been selected for [Mail Receive Protocol]
1) Select [Outgoing/Incoming E-mail Settings].
2) Select [SMTP Server Settings] and then set the following items for the SMTP
server.
z
[SMTP Server Port Number]
Enter a value in the range from 1 to 65535.
If [POP3] has been selected for [Mail Receive Protocol]
1) Select [Outgoing/Incoming E-mail Settings].
2) Select [POP3 Server Settings] and then set the following items for the POP3
server.
z
[POP3 Server Setup]
Select from [By IP Address] or [By Server Name].
z
[POP3 Server IP Address]
Enter an IP address if [By IP Address] has been selected for [POP3 Server Setup].
Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" must be a numeric value in the
range from 0 to 255. However, 224-255.xxx.xxx.xxx, and 127.xxx.xxx.xxx cannot be used.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [Next].
To Next Page
Loading...
