Fuji Xerox DocuCentre-II 3005

To Next Page

To Previous Page

Installation Procedure

Installation When Using NetWare

Configuration on the computer

Installing a print driver.

Configuration on the Machine

The following describes the configuration procedure to connect the machine to a

NetWare network.

Note • The configuration can also be performed using CentreWare Internet Services or IP Address

Setting Tool included in the CD-ROM of the Driver CD Kit.

For information on how to use CentreWare Internet Services, refer to "Using CentreWare Internet

Services" (P.63).

Using IPX/SPX

1 Display the [System Administrator Menu] screen.

1) Press the <Log In/Out> button.

2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing

[Keyboard], and select [Confirm].

Note • The default user ID is “11111”. When using the Authentication feature, a passcode is

required. The default passcode is “x-admin”.

3) Select [System Settings].

2 Enable the NetWare port.

1) Select [System Settings].

2) Select [Network Settings].

3) Select [Port Settings].

4) Select [NetWare], and select [Change Settings].

5) Select [Port Status], and select [Change Settings].

6) Select [Enabled], then select [Save].

3 Select [Close] repeatedly until the [System Settings] screen is displayed.

4 Select [Exit].

5 After the machine is restarted, print out a settings list to confirm that the NetWare port

is enabled, the NetWare device name and the network address.

For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 Machine

Status" in the User Guide.

6 Configure the machine using the CD-ROM of the Driver CD Kit.

Refer to the manual contained in the CD-ROM of the Driver CD Kit for the configuration procedure.

Using a LPD Port in NDPS