Installation Procedure
61
Installation When Using EtherTalk
9
5 After the machine is restarted, print out [Settings List] to confirm that the EtherTalk
port is enabled.
For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 Machine
Status" in the User Guide.
Configure other EtherTalk settings as necessary. Refer to "EtherTalk" (P.71) for EtherTalk
configuration.
Configuration on the Computer
The following describes the configuration procedure for the computer.
In order to print from the machine, the computer needs to have a print driver installed.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.19).
For information on how to install a print driver, refer to the manual contained in the CD-ROM included
in Adobe PostScript 3 Kit.
To Next Page
Loading...
Need help?
General
