3 Installation When Using Parallel Port
34
Installation When Using Parallel Port
3
Preparations
Prepare the following items to install the machine when using a parallel interface.
z
Parallel interface cable
z
Parallel port
z
CD-ROM of the Driver CD Kit (provided with the machine)
Installation Procedure
Installation Overview
The machine can be connected directly to a computer using a parallel interface cable.
Other computers on the same network can also print via the computer that the machine
is connected to.
The following is the configuration procedure to use a parallel interface.
z
Configuration on the machine
Configuring the parallel port on the machine.
z
Configuration on the computer
Installing a print driver.
Configuration on the Machine
The following describes the configuration procedure to use a parallel interface on the
machine.
Note • The configuration can also be performed using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to "Using CentreWare Internet
Services" (P.63).
1 Connect a parallel interface cable to the parallel interface connector on the machine.
2 Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note • The default user ID is "11111". When using the Authentication feature, a passcode is
required. The default passcode is "x-admin".
3) Select [System Settings].
3 Enable the parallel port.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Port Settings].
4) Select [Parallel], and select [Change Settings].
5) Select [Port Status], and select [Change Settings].
6) Select [Enabled], then select [Save].
To Next Page
Loading...
Need help?
General
