10 Using CentreWare Internet Services
74
Using CentreWare Internet Services
10
2) Re-enter the same password in [Re-enter Password].
12
Select the [Enable] check box to enable [TBCP Filter].
Note • The TBCP filter is set only when optional Adobe PostScript 3 Kit is installed.
13 Set the NDS.
Note • The tree name is set only when used in the Directory Service.
1) Enter a tree name into [Tree Name].
2) Enter a context name into [Context Name].
14 Select a frame type from the [Frame Type] pull-down menu under [Transport Protocol
(IPX/SPX) ].
15 Select the [Enable] check box to enable [Active Discovery] under [SLP].
16 Reflect the values as the machine's setting values.
1) Click [Apply]. A screen to enter the user name and passcode will be displayed.
2) Enter the System Administrator user ID and passcode into [User Name] and
[Password], and then click [OK].
Note • The default user ID is “11111” and passcode is “x-admin”.
3) The right frame on the web browser will change to the machine reboot display.
4) Click [Reboot Machine]. The machine will reboot and the setting value will be
reflected.
TCP/IP
This section describes the settings for TCP/IP.
1 Start a web browser.
2 Enter the machine's IP address or the Internet address to the address box on the
browser, and press the <Enter> key.
z
Example of the IP address entry
http://192.168.1.1/
z
Example of the Internet address entry
http://myhost.example.com/
To Next Page
Loading...
