EtherTalk
163
Problem Solving
16
z
Names of 32 characters
Change the last character of the printer name to a number. If the same printer name
with the last character changed has still existed on the network, increase the
changed number by 1.
If the printer name has been changed, when browsing [Protocol Settings] on the
[Properties] tab of CentreWare Internet Services, the previous printer name set
before the change is displayed. However, the changed printer name is registered on
the network, clients can browse the printer using the changed printer name. If the
printer is turned off and then on while the printer name has been changed, the printer
is activated with the changed printer name. If the same printer name has already
existed on the network, the printer name will be changed according to the rules
described above on startup.
Assign a printer name not to duplicate to other printer names on the network.
Zone Name
Zone names can be set in [Protocol Settings] on the [Properties] tab of CentreWare
Internet Services. However, if the zone name set does not exist on the network to which
the printer is connected, the zone name is automatically set as default. To set a zone
name, use the zone name that has already existed on the network.
To Next Page
Loading...
Need help?
General
