Fuji Xerox docucentre-iv C3370 - Page 626

15 Appendix
624
Appendix
15
while other one touch buttons that were used for stored programs before may be used
for address numbers. Be sure that you perform the correct operation.
USB Memory Slot on the Control Panel
z
To use the USB memory slot on the control panel, the Scan to USB Kit (optional) is
required.
z
Insert a USB memory device directly into the USB memory slot on the control panel.
If you connect a USB memory device via a USB cable, the operation is not
guaranteed.
z
To connect a USB memory device via a USB cable, use the USB 2.0 interface
connector on the rear of the left side of the machine.
IC Card Reader
There are two types of IC Card Reader you can choose: the embedded IC Card Reader
and the IC Card Reader installed on the Wing Table (optional).
Installing the IC Card Reader to the machine enhances the authentication function of
the machine. Also, you can restrict the usage of the machine and improve the security
management feature and availability of documents.
Printed Time in Force Annotation
The time you specified to print a job, the time at which the print job is started inside the
machine, and the time at which the job is actually printed may not be coincident with
one another depending on the machine status and settings or the content of the print
job. The time printed in Force Annotation is the time at which the print job is started
inside the machine.
Stored Programming
z
The following features and operations cannot be registered on a stored program.
- Registration and call of a stored program
- System settings
- The [Media Print -Text] and [Media Print - Photos] buttons on the [Services Home]
screen
- The [Store to USB] button on the [Services Home] screen
- The [Network Scanning], [Job Flow Sheets], and [Web Applications] buttons on
the [Services Home] screen (ApeosPort series models only)
- A <Custom> button to which the Network Scanning or Job Flow feature is
assigned (ApeosPort series models only)
- Address Book for the Fax/Internet Fax, E-mail, and Scan to PC services
- Buttons that cannot be selected
- The [Language] button on the [Services Home] screen
- The [Screen Brightness] button on the [Services Home] screen
- The use of a scrolling bar when you select an item
- Scrolling operation while previewing
- The [Browse] button of the Scan to PC service
- Address editing operation of the E-mail service ([Remove], [Edit], and [Close
Menu] on the pop-up menu)
- The <Energy Saver> button
z
After registering a program, you may not be able to retrieve the stored program
correctly if you execute the following operations:
- If a Watermark is registered on the program, and you change the default value of
the Watermark after registering the program