15 Appendix
646
Appendix
15
z
Color Access is available but the limit for the maximum number of pages is not
available.
Remote Authentication using the Smart Card
z
Remote Authentication can be performed in an environment where ApeosWare
Authentication Agent/ApeosWare Authentication Management, Active Directory, or
the combination of ApeosWare Authentication Agent/ApeosWare Authentication
Management and Active Directory is used.
z
Change the default realm name only when you want to use a different realm name.
z
When IC Card Reader is used for remote authentication, the combined use of the
smart card and a user ID and a passcode entries from the control panel is available
for authentication. When local authentication is used, however, the combination is
not available.
Notes and Restrictions for Using SMB
This section describes notes and restrictions to observe when using SMB.
Configuration on the Machine
z
IP addresses are managed for the entire system. Configure the settings only after
consulting your network administrator.
z
The setting of subnet mask and gateway addresses may be required depending on
the network environment. Consult your network administrator and configure the
required settings.
z
When the port status is set to [Enabled], it may automatically switch to [Disabled] if
the machine has insufficient memory. In this case, either set an unused port to
[Disabled] or adjust the assigned memory size.
z
Adjust the receiving buffer size for SMB in [Receiving Buffer - SMB] according to
usage. If the receiving buffer size is smaller than the transmitted data, the machine
may not be able to receive the data.
Configuration on the Computer
z
IP addresses are managed for the entire system. Configure the settings only after
consulting your network administrator.
z
When setting the network such as IP addresses with a host used under the Network
Information Service (NIS), consult your NIS administrator.
Turning Off the Machine
Check the following points when turning off the machine:
z
When [Receiving Buffer - SMB] is set to [Spool to Memory]
All print data spooled within the machine memory, including the data which is being
printed, is erased. The print data does not remain when the machine is turned on
again.
However, if the machine was turned off immediately after a computer instructed a
print job, the job may remain on the computer. In this case, when the machine is
turned on, the data stored on the computer is printed before any jobs instructed
subsequently.
To Next Page
Loading...
