Output Format
149
Copy
3
Allows you to specify text from three preset texts, or text registered in the System Settings.
For information on how to register text, refer to "5 Tools" > "Common Service Settings" > "Secure Watermark" > "Secure
Watermark Effect" > "Custom Secure Watermark 1 to 3" in the Administrator Guide.
îš„ Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
Note • If the [Original Orientation] setting differs from the actual document orientation, the machine may
not detect the top of the document correctly.
z
Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
z
Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder.
Folding (Outputting Bi-Folded/Tri-Folded Paper)
This feature allows you to fold copies in half or in three.
When the C3 Finisher with Booklet Maker (optional) is installed, [Single Fold] is available.
When the Booklet Maker Unit for Finisher-B1 (optional) is installed, you can also crease the
output sheet in half.
When the Folder Unit CD1 (optional) is installed, [Z Fold] and [C Fold] are also available.
Note • The supported paper orientation is only . Select the tray whose orientation is set to .
• [Z Fold] and [C Fold] can only be applied to A4 and 8.5 x 11" paper.
• This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
1 Select [Folding].
2 Select any option.
îš„ Off
Does not fold copies.
îš„ Z Fold
Folds copies in three with the printed side inside
or outside.
printing surface comes inside printing surface comes outside
To Next Page
Loading...
Need help?
General
