3 Copy
86
Copy
3
Copying Procedure
This section describes the basic copy procedures. The following shows the reference section
for each procedure.
Step 1 Loading Documents ..........................................................................................................................................................86
Step 2 Selecting Features .............................................................................................................................................................88
Step 3 Entering a Quantity...........................................................................................................................................................89
Step 4 Starting the Copy Job .......................................................................................................................................................90
Step 5 Confirming the Copy Job in Job Status.........................................................................................................................91
Step 1 Loading Documents
The following two methods are available to load documents:
îš„ Document Feeder
z
Single sheet
z
Multiple sheets
îš„ Document Glass
z
Single sheet
z
Bound documents, such as books
Document Feeder
The document feeder supports single and multiple sheet documents with sizes from 125 x
85 mm (Standard size: A5, A5 ) to 297 x 432 mm (Standard size: A3, 11 x 17").
The document feeder automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard document size,
refer to "Original Size (Specifying the Scan Size for the Document)" (P.122).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
The document feeder accepts the following number of sheets.
Important • To avoid paper jams, use the document glass for folded or wrinkled documents,
cut-and-pasted documents, curled paper, or back carbon paper.
• When Duplex Automatic Document Feeder B1-C is installed, the lightweight paper of 38 - 49 gsm
cannot be scanned 2 sided.
For information on how to copy mixed sized documents, refer to "Mixed Size Originals (Scanning Different Size Documents
Simultaneously)" (P.123).
Document Type (Weight)
Number of Sheets
Duplex Automatic
Document Feeder
B1-C
Duplex Automatic
Document Feeder
B1-PC
Lightweight paper (38 - 49 gsm) 110 sheets 130 sheets
Plain paper (50 - 80 gsm) 110 sheets 130 sheets
Heavyweight paper (81 - 128 gsm) 75 sheets 85 sheets
To Next Page
Loading...
Need help?
General
