4 Fax
236
Fax
4
Example of specifying a destination:
îš„ Secure Polling (F Code Method)
When a folder is set on a remote machine, you can perform secure polling for the folder by
specifying its F code (sub-address) and password (if set up).
If you use your machine to perform secure polling for a folder on a remote machine, obtain
the F Code (sub-address) and password of the target folder.
If you use a remote machine to perform secure polling for a folder on your machine, give the
following information.
Note • The DTMF method is available for Remote Folder. The supported signals are numerals, "*", and "#"
only.
A file received in the folder can automatically be printed depending on the folder settings. For information on the folder
settings, refer to "Configuring/Starting Job Flow" (P.361).
Depending on the report print settings, a Folder Report may not be printed even after a file is received in a folder. For
information on the Folder Report setting, refer to "5 Tools" > "Common Service Settings" > "Reports" > "Folder Report" in the
Administrator Guide.
For information on how to print files received in a folder, refer to "Printing Files in a Folder" (P.358).
Sending to Folder (F Code Method)
1 Select [F Code]
2 Select [On].
3 Select the [F Code] box, and enter an F code using the displayed keyboard or the numeric
keypad.
Note • You can enter up to 20 digits for the F code.
4 If necessary, select the [Password] box, and enter a password using the displayed keyboard
or the numeric keypad.
Note • You can enter up to 20 digits for the password.
îš„ Off
The F code transmission is not used.
F Code (sub-address) : 0 (to designate an F Code transmission) and the folder number
of a folder on the remote machine
Password (if set up) : The password of the remote folder
F Code (sub-address) : 0 (to designate an F Code transmission) and the folder number
of the target folder
Password (if necessary) : The password of the target folder
To Next Page
Loading...
Need help?
General
