Using the Operator Panel Menus 109
*1
This item is displayed when Wi-Fi Direct is set to Enable and WPS Setup is set to PIN Code.
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wi-Fi is set to On.
• Reset Wi-Fi
Purpose:
To reset the wireless connection settings. After executing this function, all information about the access point is
cleared.
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wi-Fi is set to On.
•TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
*1
This item is displayed when the IPsec is enabled on the CentreWare Internet Services.
NOTE:
• To set an IP address for IPv6 in Dual Stack mode, use the CentreWare Internet Services. For more information, refer to the
online Help on the CentreWare Internet Services.
PassPhrase Show Passphrase Displays the passphrase. Confirm it when you enter the passphrase to
your mobile device.
Print Passphrase Prints the passphrase. Confirm it when you enter the passphrase to
your mobile device.
Reset Passphrase Resets the passphrase.
WPS Setup PushButtonControl Configures the Wi-Fi Direct settings with the security method of WPS-
PBC.
PIN Code Configures the Wi-Fi Direct settings using the PIN code to your mobile
device.
PIN Code
*1
Print PIN Code Prints the PIN code. Confirm it when you enter the PIN code to your
mobile device.
Reset PIN Code Resets the PIN code.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv4 Ethernet/
IPv4 Wi-Fi
Get IP
Address
DHCP/AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator panel.
IP Address Manually sets the IP address allocated to the printer.
Subnet Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.
IPv4 Wi-Fi
Direct
IP Address Displays the IPv4 address allocated to the printer when using
Wi-Fi Direct.
Subnet Mask Displays the subnet mask when using Wi-Fi Direct.
IPsec*
1
Disable* Disables the IPsec.
Enable Enables the IPsec.
To Next Page
Loading...
Need help?
General
