Using the Operator Panel Menus 115
• Auto Regi Adjust
Purpose:
To automatically start adjusting color registration.
Values:
• Adjust ColorRegi
Purpose:
To start adjusting color registration when you need.
Color registration adjustments are required when the printer is initially installed and after the printer is moved.
Values:
• Clean Developer
Purpose:
To rotate the developer motor and stir the toner in the toner cartridge.
• Toner Refresh
Purpose:
To use up a toner cartridge when you need to replace it before the end of its life, or to stir the toner in a new toner
cartridge.
Values:
•BTR Refresh
Purpose:
To specify whether to execute counter measures for curling/separating discharge of the paper.
Values:
• Initialize NVM
Purpose:
To initialize NVM for system parameters. After executing this function and rebooting the printer, the menu
parameters, except the parameters for the network, are reset to their factory default values.
See also:
• "Resetting to Factory Defaults" on page 126
On* Automatically adjusts color registration.
Off Does not automatically adjust color registration.
Auto Adjust Automatically performs color registration correction.
Yellow Cleans the toner in the yellow toner cartridge.
Magenta Cleans the toner in the magenta toner cartridge.
Cyan Cleans the toner in the cyan toner cartridge.
Black Cleans the toner in the black toner cartridge.
Off* Does not automatically execute counter measures for curling/separating
discharge of the paper.
On Automatically executes counter measures for curling/separating discharge of the
paper.
To Next Page
Loading...
Need help?
General
