Basic Operation 19
Status of Wi-Fi LED
This section describes when the (Wi-Fi) LED lights up or blinks.
See also:
• "Wireless Problems" on page 155
*
You can enable/disable the Wi-Fi settings. For more information, see "Wi-Fi" on page 111.
(Wi-Fi) LED Wi-Fi
settings
*
Printer Status
Off N/A Connected to the network via Ethernet cable; Regardless of the Wi-Fi
setting, wireless connection is not available when an Ethernet cable is
connected to the printer
Off —
On The printer enters the power saver mode
Failed to connect with Wireless LAN access point or router
On On Wireless link established
Blinking normal On Searching/Connecting with wireless LAN access point or router
Blinking slowly On Searching/Connecting with WPS access point or router during wireless
operation
Connecting with a mobile device using Wi-Fi Direct
®
Blinking fast On Received an invitation from a mobile device to connect using Wi-Fi Direct
To Next Page
Loading...
Need help?
General
