Printing Basics 83
NOTE:
• Up to 5 envelopes can be loaded in the standard 150 sheet tray.
• If you do not load envelopes in the standard 150 sheet tray right after they have been removed from the packaging, they may
bulge. To avoid jams, flatten the envelopes before loading them in the standard 150 sheet tray. When flattening the envelopes,
firmly press down on the entire surface of the envelopes as shown below.
• If envelopes are still not fed correctly, curl the edge of the envelopes as shown in the following illustration. The amount of the
curl should be 5 mm (0.20 inches) or less, 2 or 3 mm (0.08 or 0.12 inches) is recommended. The area of the curl should be
8 – 10 mm (0.32 – 0.39 inches) from the top edge of the envelopes. Do not curl the envelopes too much or make a crease.
• To confirm the correct orientation of envelopes, see the instruction on the Envelope/Paper Setup Navigator on the print driver.
Loading Letterhead in the Standard 150 Sheet Tray
Load the letterhead in the printer with the print side facing up. Make sure that the title on the letterhead enters the
printer first.
To Next Page
Loading...
Need help?
General
