Fuji Xerox DocuPrint CP475 AP User Manual

[System Settings]
133

Only the jobs performed after the start of the Image Log Control feature will be covered by the Image Log
Control feature.

Because the images to be controlled are created based on the input images, the images will not always be
the same as the output images. The following information is added or edited during output; thus, the images
will not be reflected.

Layout change during output

Separator

Banner

Annotation

Form Overlay (Print)

Images with higher resolution than the input image cannot be created regardless of the setting of
[Resolution] under [Image Log Generation]. If the resolution of the input image is lower than the setting of
[Resolution] under [Image Log Generation], the device creates an image with the same resolution of the
input image.

Up to 8191 pages of images can be created. If more than 8191 pages of images are input into the device,
even if [All Pages] is selected for [Page Range] under [Image Log Generation], not more than 8191 pages can
be created.

In case of insufficient space for images in storage, the device operates as follows according to the [Assurance
Level] settings under [Image Log Generation].

[High]: A job is cancelled.

[Low]: A job is executed. However, the warning will be displayed at the end of the job and notifies the user
that the image creation failed.

When an error occurs during generating an image log, the device operates in accordance with the setting of
[Image Log Generation] > [Assurance Level] as follows.

[High]: Replaces the image to an error image (1x1 pixels) and indicates a system error. Turn off the device
and confirm that the control panel is lit off, and then turn on the device again.

[Low]: Replaces the image to an error image (1x1 pixels) and records the error information after finishing
the job.

Up to 2000 image logs can be stored in the device.

The text size of image logs differs depending on the setting of [Resolution] under [Image Log Generation].
Refer to the following table when you set the resolution.
[Image Log Control]
Set whether or not to use the Image Log Control feature.
[Image Log Target]
Set whether or not to create image logs per job type.
[Image Log Generation]
Set the image data to manage as an image log. One image log file (PDF format) is created
per one job.
Resolution Size for Color
Jobs
Size for B&W
Jobs
Remarks
200 dpi 6 pt 6 pt Adequate level for normal document.
100 dpi 10 pt 14 pt Large size characters are legible.
72 dpi 12 pt 18 pt Title size characters are legible.
50 dpi 16 pt 24 pt Characters are illegible. Suitable for
Preview.
25 dpi 24 pt 32 pt Characters are illegible. Suitable for
Thumbnail view.

Fuji Xerox DocuPrint CP475 AP Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CP475 AP
Category	Printer
Language	English