Fuji Xerox DocuPrint CP475 AP

7 Advanced Settings
148
 [Port Number]
Enter a port number for Port 9100.
Important

Do not use the numbers assigned to the other ports.
[SNMP]
 [Port Status]
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the device on the network.
[Receive Email]
 [Port Status]
Select [Enabled] when you receive emails.
[Email Notification Service]
 [Port Status]
Select [Enabled] when you use the Email Notification Service.
The Email Notification Service notifies you of the device status or the completion of a print
job by email.
Note

[Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status], [Jam Status], [Interlock
Status], and [Fault Notice] are notified as the device status.

You can configure the Email Notification Service in CentreWare Internet Services. For more information, refer
to the help of CentreWare Internet Services.
[UPnP Discovery]
 [Port Status]
Select [Enabled] to use UPnP.
 [Port Number]
Enter a port number for UPnP communication.
Important

Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, and Web Services on
Devices (WSD)).
[WSD]
 [Port (Print from Desktop)]
Select [Enabled] to use WSD Print.
Set this when you search a device on a network from Windows OS.
 [Port Number]
Enter a port number.
Important

Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, and Web Services on
Devices (WSD)).