Fuji Xerox DocuPrint CP475 AP User Manual

7 Advanced Settings
160
 [HTTP - SSL/TLS Communication]
Select whether or not to enable only HTTP SSL/TLS communications.
Important

If [Enable HTTPS Only] is set, each port of [UPnP Discovery] and [WSD] is paused.
 [HTTP - SSL/TLS Port Number]
Set the port number used for HTTP SSL/TLS communication.
Important

Do not use the numbers assigned to the other ports.
 [SMTP - SSL/TLS Communication]
Configure the SSL/TLS communications.
 [Disabled]
The device does not communicate in SSL/TLS.
 [STARTTLS (If Available)]
The device verifies the certificate and communicates in SSL/TLS. If the verification fails, the
device does not communicate in SSL/TLS.
 [STARTTLS]
The device verifies the certificate and communicates in SSL/TLS. If the verification fails, the
device cannot perform communication.
 [SSL/TLS]
The device communicates in SSL/TLS.
 [ThinPrint - SSL/TLS Communication]
Select whether or not to enable the SSL/TLS communications.
 [Device Certificate - Client]
Select a certificate for HTTP SSL/TLS communications.
 [Verify Remote Server Certificate]
When the device is operated as an SSL client, select whether or not to verify the certificate
of the remote server.
[IPsec Settings]
 [IPsec Settings]
Allows you to encrypt the network communication in units of the packet to communicate
safely.
Note

When Wireless Network Kit (optional) is installed on the device, this item is available only for one interface.

For [IKE Authentication Method], [Preshared Key], [DH Group], and [PFS Settings], consult your network
administrator.

[IKE Authentication Method]
Set the IKE authentication method.

Fuji Xerox DocuPrint CP475 AP Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CP475 AP
Category	Printer
Language	English