Fuji Xerox DocuPrint CP475 AP User Manual

Emulation
283

Matrix 2 of 5
 Forms
You can use ESC/P to register forms.
The following shows the number of forms you can register.
Note

When the number of registered forms already has reached the upper limit or when the full capacity assigned
for forms is full, attempting to register a new form will fail. In this case, any error will not be notified.
Setting Menu Items Related to the ESC/P Mode
 [Port Settings]
Set the port used in emulation modes under [Device] >[Connectivity & Network Setup] >
[Port Settings]

Port Status (LPD/IPP/USB-/Port 9100)
Enables the ports to be used in the ESC/P emulation mode.

[USB - Print Mode]
Sets the print mode of the USB port so that it can be used by ESC/P emulation. Select
[ESC/P] as the print mode.
Note

[USB - Print Mode] sets the method of processing data received from host interfaces. If this is set to [ESC/P]
here, the device will not switch languages automatically as described in "Switching between Printer
Languages" (P.281).

The print mode can also be specified for each protocol (LPD, IPP, Port 9100, or WSD) from CentreWare
Internet Services.
 [Delete Form]
[Device] > [App Settings] > [Print Settings] > [Delete Form] allows you to delete forms
registered with the device.
ESC/P
Storage not installed 64
Storage installed 64

Fuji Xerox DocuPrint CP475 AP Specifications

General

Brand	Fuji Xerox
Model	DocuPrint CP475 AP
Category	Printer
Language	English