Printer Connection and Software Installation 111
b Enter the WEP key, and then press the button.
c Select the desired transmit key from Auto or WEP Key 1 to WEP Key 4, and then press the button.
The Restart Printer to apply setting message appears.
Proceed to step 12.
9 Select WEP for the encryption method, and then press the button.
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
10 Enter the WEP key, and then press the button.
11 Select the desired transmit key from WEP Key 1 to WEP Key 4, and then press the button.
The Restart Printer to apply setting message appears.
12 Turn off the printer, and turn it on again to apply the settings.
Wireless settings are correctly configured.
IMPORTANT:
• If the optional hard disk unit is not installed on your printer, note that the data in the memory are cleared when the printer
is turned off.
To Next Page
Loading...
Need help?
General
