Troubleshooting 229
Random Spots/Blurred Images
Problem Action
The printed result has random
spots or is blurred.
Ensure that the toner cartridge is installed correctly.
See also:
• "Installing a Toner Cartridge" on page 256
If the problem persists, ensure that the drum cartridge is installed correctly.
Ensure that the drum cartridge is installed correctly.
See also:
• "Replacing the Drum Cartridge" on page 257
• "Installing a Drum Cartridge" on page 260
If the problem persists, clean the chute above the regi roll inside the rear of the printer
with a dry cloth.
Clean the chute above the regi roll inside the rear of the printer with a dry cloth.
See also:
• "Rear View" on page 33
If the problem persists, lower the transfer unit voltage.
Lower the transfer unit voltage.
1 Check the transfer unit voltage in the Adjust TransUnit menu.
2 Decrease the voltage.
See also:
• "Adjust TransUnit" on page 183
If the problem persists, replace the drum cartridge if you have a spare cartridge.
Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 257
• "Installing a Drum Cartridge" on page 260
If the problem persists, replace the fusing unit as instructed in "Replacing the Fusing
Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger Roll" on page 261.
Replace the fusing unit if you have a spare unit.
See also:
• "Replacing the Fusing Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger
Roll" on page 261
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
To Next Page
Loading...
Need help?
General
