238 Troubleshooting
Damage on the Leading Edge of Paper
The Top and Side Margins Are Incorrect
Problem Action
The output is damaged on its
leading edge.
When using the bypass tray, reverse the paper and then try again.
If the problem persists, change the paper with another one and then try again.
When using the standard 550 sheet tray or optional 550 sheet feeder, change the
paper and then try again.
Change the paper with another one and then try again.
If the problem persists, use the standard 550 sheet tray or optional 550 sheet feeder
in place of the bypass tray.
Use the standard 550 sheet tray or optional 550 sheet feeder in place of the bypass
tray.
If the problem persists, replace the fusing unit as instructed in "Replacing the Fusing
Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger Roll" on page 261.
Replace the fusing unit if you have a spare unit.
See also:
• "Replacing the Fusing Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger
Roll" on page 261
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
Problem Action
The top and side margins are
incorrect.
Ensure that the margins are set correctly on the application being used.
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
To Next Page
Loading...
Need help?
General
