Troubleshooting 233
Mottle
Ghosting
Problem Action
The printed result has mottled
appearance.
Verify that the print media recommended for the printer is being used.
If you use non-recommended print media, use the print media recommended for the
printer.
If the problem persists, raise the transfer unit voltage.
Raise the transfer unit voltage.
1 Check the transfer unit voltage in the Adjust TransUnit menu.
2 Increase the voltage.
See also:
• "Adjust TransUnit" on page 183
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
Problem Action
The printed result has ghosting. If the type of the ghosting is positive ghost:
Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 257
• "Installing a Drum Cartridge" on page 260
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
If the type of the ghosting is negative ghost:
Verify that the print media recommended for the printer is being used.
If you are using non-recommended print media, use the print media recommended
for the printer.
See also:
• "Ghost Control" on page 186
If the problem is solved, adjust the transfer bias.
If the problem persists, replace the drum cartridge if you have a spare cartridge.
Adjust the transfer bias.
1 On the operator panel, press the (Menu) button and select Admin Menu →
Maintenance Mode → Adjust TransUnit.
2 Adjust the setting for the type of print media being used.
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
To Next Page
Loading...
Need help?
General
