Troubleshooting 231
Streaks Appear on the Output
Problem Action
Streaks appear on the output. The toner cartridge may be low or need to be replaced. Confirm the amount of toner
in the toner cartridge.
1 Check the toner level in the Status Monitor window.
2 Replace the toner cartridge as necessary.
If the problem persists, stir the developer in a drum cartridge.
Stir the developer in a drum cartridge.
1 On the operator panel, press the (Menu) button and select Admin Menu →
Maintenance Mode → Clean Developer.
2 Press the button.
If the problem persists, replace the drum cartridge if you have a spare cartridge.
Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 257
• "Installing a Drum Cartridge" on page 260
If the problem persists, replace the fusing unit as instructed in "Replacing the Fusing
Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger Roll" on page 261.
Replace the fusing unit if you have a spare unit.
See also:
• "Replacing the Fusing Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger
Roll" on page 261
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
To Next Page
Loading...
Need help?
General
