Fuji Xerox DocuPrint P455 D

236 Troubleshooting
 Banding
 Auger Mark
Problem Action
The printed result has banding. Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 257
• "Installing a Drum Cartridge" on page 260
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
Replace the fusing unit if you have a spare unit.
See also:
• "Replacing the Fusing Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger
Roll" on page 261
If the cause of the problem is not located, contact the Fuji Xerox local representative
office or an authorised dealer.
Replace the transfer unit and the retard roll.
See also:
• "Replacing the Fusing Unit, Transfer Unit, Retard Roll, Feed Roll and Nudger
Roll" on page 261
If the cause of the problem is not located, contact the Fuji Xerox local representative
office or an authorised dealer.
Problem Action
The printed result has auger
mark.
Stir the developer in a drum cartridge.
1 On the operator panel, press the (Menu) button and select Admin Menu →
Maintenance Mode → Clean Developer.
2 Press the button.
If the problem persists, replace the drum cartridge if you have a spare cartridge.
Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 257
• "Installing a Drum Cartridge" on page 260
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.