35
1
Use the procedure below to erase recorded images.
To erase all the recorded images, see P.86.
1
Display the image to be erased. (See “To View Images
(Playback)”.)
2
When you press function button [2], the image is
displayed on the rear display panel for erase
confirmation.
• If the image is protected (☞ P.88), the error tone sounds and an error
message is displayed for about 3 seconds.
• If DPOF settings have been specified for the image, the error tone
sounds and an erase confirmation message is displayed. Check the
image and then proceed to step 3.
3
Press function key [4] to erase the selected image. The
next recorded image then appears.
Erasing Single Recorded Images
• To cancel the procedure, press function key [1].
• To continue erasing images, repeat steps 2 and 3.
To Next Page
Loading...
