Combination massage of mechanical (knead balls) and air
46
• When you have selected the “NECK FLEX”, “EXTREME
KNEAD”, “EXTREME TAPPING” or “ROLLING”, it is
necessary to set initially the shoulder position.
Although the front and rear positions of knead balls can also
be set at this time, this is effective only when the “NECK
FLEX”, “EXTREME KNEAD” or “EXTREME TAPPING”
has been selected.
Adjust the shoulder position with the switch or
HEIGHT ADJUSTMENT [S] or [T] and adjust the front
and rear position of knead balls with the switch.
• If you select the “KNEAD UP”, “KNEAD DOWN”,
“TAPPING”, “WAVELET”, “RUBBING”, “DEEP KNEAD
UP”, “DEEP KNEAD DOWN”, “SHIATSU”, “STRETCH”
or “3D” after selecting the “ROLLING”, the selected
movement is combined with the “ROLLING”.
3. Selected function is started.
• When adjusting the massage functions, refer to the
adjustment for each massage.
Adjustment during the movement of mechanical (knead
balls) massage functions (See P34.)
Adjustment during the movement of air massage function
(See P38.)
* When the function is adjusted after pressing the [MENU]
button during a combination massage, the screen as shown
below will be displayed.
POINT
NARROW NORMAL
POINT
PART
OFF
OFF
OFF
ON
ON
ON
STOP
STAR
RESE
AUTO
FUNCTION
AIR
REPEAT
SKIP
SHDR
MENU
ARM
ENTER
FOOTREST RECLINER
RESET
VIBRATION HEATER
HEIGH
ADJUSTMEN
To Next Page
Loading...
