Fujiiryoki SKS-1850 - Turning the power on; Check items

Preparation before use
11
Turning the power on
1. Insert the power cord plug in the
receptacle.
2. Turn on the power supply switch.
• Power supply switch is provided at the back of
left arm rest.
• As the power supply is turned on, the screens
shown at right are displayed alternately on the
LCD display, which is in the initial state.
Check items
1. Check around the chair.
① Confirm there is nobody, pet or obstruct at the back of main unit, under
the foot rest, or others.
<Standby position>
Pressing [START/RESET] button at the start of massage raises the foot rest
automatically by about 50°.
* Safety around the chair must be confirmed.
2. Check the main unit of chair.
① Raising the back pad, check the cloth
over the back rest for tear. Check also
other section for any tear.
* When any tear has been discovered
regardless how minor the size, stop
the use immediately, disconnect the
power supply plug and contact your
dealer for repair.
② Confirm that none of the power cord,
Remote Controller cord or any other item
is caught up by the main unit.
③ Check the power cord, Remote Controller
cord or power supply plug for damage, or
the plug and pins for dirt.
④ Check the knead balls position before
sitting on the chair.
• Knead balls
are positioned
normally at the
stored position
(retracted to
the bottom of
the back rest).
⑤ Check the foot rest position before sitting
on the chair.
• Attempting to sit while the foot rest is in
the raised position could cause injury.
Lower the foot rest by pressing the
FOOTREST [T] or [RESET] button.
* Pressing the [RESET] button retracts
also the back rest to the stored
position.
FOOTREST RECLINE
R
RESET
VIBRATION HEATER
Stored
position