Fujiiryoki SKS-1850 - Adjustment during the movement of mechanical (knead balls) massage functions; Adjusting mechanical intensity; Selecting massage section (point;whole;part)

Adjustment during the movement of mechanical (knead balls) massage functions
34
1. To adjust the intensity of mechanical (knead balls)
massage.
Adjust by pressing the switch and then press
the [ENTER] button.
• Mechanical (knead balls) massage intensity can be adjusted
at 7 steps.
• It is set at “4” initially.
• This can be set only during the
movement oF “KNEAD UP”,
“KNEAD DOWN”, “TAPPING”,
“WAVELET”, “SHIATSU”,
“ROLLING” or “STRETCH”.
2. To select a massaging section (point/whole/part)
Press the [MENU] button and select a “PART” with
the switch. Select then the
“POINT/PART/WHOLE” with the switch and
finally press the [ENTER] button.
• When the “WHOLE” has been selected, set the shoulder
position first of all. You can set also the front and rear
position of knead balls at this time but it is effective only
when the “NECK FLEX”, “EXTREME KNEAD” or
“EXTREME TAPPING” has been selected.
Adjust the shoulder position with the switch or
HEIGHT ADJUSTMENT [S] or [T] and the front and
rear position of knead balls with the switch.
* When the massage has already been used with the “NECK
FLEX”, “EXTREME KNEAD”, “EXTREME TAPPING”
or “ROLLING”, the shoulder position had been set so that
it is not necessary to set again.
e f
PART
STOP
STAR
T
/
RESE
T
AUTO FUNCTION
AIR
REPEAT
SKIP
SHDR
MENU
ARM
ENTER
FOOTREST RECLINER
RESET
VIBRATION HEATER
HEIGH
T
ADJUSTMEN
T