A26361-K554-Z100-2-7619 9
Preparation for use and operation
!
Please pay attention to the safety information provided in the chapter "Important notes"
and in the manual "Safety, Guarantee and Ergonomics".
Unpacking and checking the delivery
It is recommended not to throw away the original packaging material! It may be required for
reshipment at some later date.
Ê Unpack all the individual parts.
Ê Check the delivery for damage incurred during transportation.
Ê Check whether the delivery agrees with the details in the delivery note.
Should you discover that the delivery does not correspond to the delivery note, notify your local
sales outlet immediately.
i
If you have received drives or boards with your PC, please do not install them until
after first-time setup. How to install drives and boards is described in the chapter
"System expansions".
Setting up the PC
!
When installing your PC, give consideration to the recommendations and safety notes in
the manual "Safety, Guarantee and Ergonomics".
Set up the PC only in its correct orientation. The points to observe are illustrated on the
following pages.
Do not expose the PC to extreme environmental conditions (see chapter "Technical
data"). Protect it from dust, humidity and heat.
Provide at least 200 mm of clearance on the left, in front of and behind the ventilator area
of the system unit to ensure adequate ventilation. Do not cover the ventilation areas of the
monitor and the system unit.
Do not place several system units one above the other.
We recommend that you place your equipment on a surface with good anti-slip qualities. In view of
the multitude of different finishes and varnishes used on furniture, it is possible that the rubber feet
of the devices will mark the surface they stand on.
To Next Page
Loading...
Need help?
General
