Indicators and switches Preparation for use and operation
A26361-K554-Z100-2-7619 15
5 - Hard disk indicator
The indicator lights up when the hard disk drive of the system unit is accessed.
Switching on the PC for the first time
If the PC is integrated into a network, the user and server details as well as the network protocol are
required. Contact your network administrator if you have any questions about these details.
When you switch on your PC for the first time the supplied software is set up and configured.
If you require the license number of Windows, you will find it either on a sticker on your PC or
printed on the front cover of the Windows manual provided.
Ê Switch your monitor on.
Ê Switch the system unit on with the ON/OFF switch.
The power-on indicator lights green and the PC is started.
i
While the PC boots, the screen remains dark for up to a minute depending on the system
configuration. To see the start-up messages, you can switch off this standard setting in
the BIOS Setup in the Quiet Boot entry.
Ê Adjust the brightness if necessary (see the Operating Manual for the monitor).
Some variants require you to start the software installation by pressing the function key [F1]
[F1][F1]
[F1].
i
Once the installation has been started the PC must not be switched off.
You should only reboot the PC during installation if you are requested to do so. Otherwise
the installation will be not be performed correctly. If a fault occurs in the installation the
contents of the hard disk must be completely restored.
Ê During installation follow the instructions on the screen.
Consult the operating system manual if there is anything unclear about the requested input data.
i
You will find further information about the system, drivers, utilities, updates, and manuals
etc. on the "Drivers & Utilities" CD supplied.
To Next Page
Loading...
Need help?
General
