1. Press the SET TEMP. ( ) ( ) buttons to change the custom
code between
→ → → . Match the code on the display to
the air conditioner custom code. (Initially set to .) If the custom
code does not need to be selected, press the MODE button, and
proceed to STEP 2.
2. Press the TIMER MODE button and check that the indoor unit can
receive signals at the displayed custom code.
3. Press the MODE button to accept the custom code, and proceed
to STEP 2.
4. After completing the function setting, be sure to disconnect the
power supply and then reconnect it.
NOTES:
• The air conditioner custom code is set to “
” prior to shipment.
• The remote controller resets to custom code “
” when the batteries on the remote controller
are replaced. If you use a custom code other than code “
”, reset the custom code after re-
placing the batteries.
• If you do not know the air conditioner custom code setting, try each of the custom codes (
→
→ → ) until you find the code that operates the air conditioner.
- 27 -
CASSETTE TYPE
AUYG18-24LVL
To Next Page
Loading...
