Fujitsu aoyg45lbt8 - Field Setting Procedure; Function Setting Procedure Guide

En-14
Setting method(1)
Use the MODE/EXIT, SELECT, and ENTER buttons to congure settings according to the procedures below.
1: Function Setting
2: Setting the
rst 2 digits
3: Setting the
last 2 digits
(When [F3] to [F9] are displayed, continue to press the
SELECT button until [F2] is displayed.)
(Continue to press the SELECT button until the
desired number appears at the last 2 digits.)
: Press the “MODE/EXIT” button.
: Press the “SELECT” button.
: Press the “ENTER” button.
(Continue to press the SELECT button until the
desired number appears at the last 2 digits.)
Press “ENTER” button to return to “2.Setting the rst 2 digits”
(If there is no operation for 5 seconds after the setting, the display
will return to “2: Setting the rst 2 digits”.)
(If there is no operation for 5 seconds after the setting, the
display will return to “2: Setting the rst 2 digits”.)
(Press the MODE/EXIT button to cancel the setting mode.)
Setting is complete when the lamp lights up
Setting is complete when the lamp lights up
(Press the ENTER button
for more than 3 seconds.)
(Press the ENTER button for
more than 3 seconds.)
7 seg. display
First 2 digits
Last 2 digits
(Blinking)
(Blinking)
(Blinking) (Blinking)
(Blinking)
(Blinking)
(Blinking)
(Blinking)
(Blinking)
(Blinking)
Every press of the “SELECT”
button will change the setting
number for the rst 2 digits.
MODE/EXIT
MODE/EXIT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
SELECT
ENTER
ENTER
ENTER
ENTER
EXIT
ENTER
ENTER
MODE/EXIT
9379069366_IM.indb 14 15/11/2555 11:18:25