113
Safety Precautions
arrows U
CE RF Power Table
Radio type
(Description)
Transmitter Frequency /
Maximum Output Power
GSM
(GSM900)
880-915MHz / 33.5 dBm
GSM
(DCS1800)
1710-1785MHz / 30.5 dBm
UMTS (FDD I) 1920-1980MHz / 23.5 dBm
UMTS (FDD
VIII)
880-915MHz / 23.5 dBm
LTE (FDD 1) 1920-1980MHz / 25.0 dBm
LTE (FDD 3) 1710-1785MHz / 25.0 dBm
LTE (FDD 8) 880-915MHz / 25.0 dBm
WLAN
2.4GHz (IEEE
802.11b)
2400-2483.5MHz / 17.0 dBm
WLAN 2.4GHz
(IEEE802.11g)
2400-2483.5MHz / 15.0 dBm
WLAN
2.4GHz (IEEE
802.11n)
2400-2483.5MHz / 15.0 dBm
WLAN
5GHz (IEEE
802.11a)
5150-5350MHz / 15.0 dBm
WLAN
5GHz (IEEE
802.11a)
5470-5725MHz / 15.0 dBm
WLAN
5GHz (IEEE
802.11n)
5150-5350MHz / 15.0 dBm
WLAN
5GHz (IEEE
802.11n)
5470-5725MHz / 15.0 dBm
WLAN
5GHz (IEEE
802.11ac)
5150-5350MHz / 12.0 dBm
WLAN
5GHz (IEEE
802.11ac)
5470-5725MHz / 12.0 dBm
Bluetooth
(Bluetooth)
2400-2483.5MHz / 10.5 dBm
RFID (NFC) 13.56MHz/-19 dBμA/m at 10m
The manufacturer of this product is Fujitsu Connected
Technologies Ltd. with its registered place of business at
Chuorinkan 7-10-1 Yamato, Kanagawa 242-0007, Japan.
Federal Communications Commission
(FCC) Notice
・This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions :
① this device may not cause harmful interference, and
② this device must accept any interference received, including
interference that may cause undesired operation.
・Changes or modifications made in or to the radio phone, not
expressly approved by the manufacturer, will void the user's
authority to operate the equipment.
・The device complies with 15.205 of the FCC Rules.
Note:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help and for additional suggestions.
To Next Page
Loading...
