Operation
Adjusting the brightness
► Press the button to open the Brightness setting window.
► Press the
button or the button to set the desired brightness.
► Press the
button to close the m enu.
Performing auto-adjustment of the monitor
This function is only intended for analogue image transmission (VGA).
► Press the
AUTO
button for about 1 second.
The Auto Processing m
essage appears.
Picture quality and position a re set to optimum values for your system.
Locking the OSD me
nu
The OSD menu can be locked to preven t accidental or u nauthorised change s to th e monitor settings.
► Press the
MENU
button and keep it pressed for a few seconds while you switch the
monitor on using the ON/OFF button or the ON/OFF touch sensor.
The message OSD
locked / unlocked is displayed.
Please procee
d in the same manner to release the locked OSD menu again.
Locking the ON/OFF button or ON/OFF touch sensor
The ON/O FF button or ON/O FF touch sensor can be locked to prevent accidental
or unauthorised changes to the screen settings.
► Press the
ECO
button and
INPUT
button at the same time for a few seconds.
The m essage Power button locked / unlocked is displayed.
In order to unlock the O N/O FF button or ON/O FF touch sensor, do the same again.
24 Fujitsu
To Next Page
Loading...
