Working with the noteb ook
Connecting the mains adapter to the Port R eplicator
Make sure that the proper AC adapter is connected: Output: 19.5 V / 16.9 A (330 W).
1
3
3
2
► Connect the power cable (1) to the power adapter provided for the device,
see ch apter "
Technical data", Page 77.
► Plug the power cable into the mains s ocket (2).
► Connect the mains adap ter cable to the DC jack (DC IN) of th e Port Replicator (3).
When the notebook is connected to a Port Replicato r, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as th e notebook is connected to a Port Replicator of the same type.
46 Fujitsu
To Next Page
Loading...
