Getting started
Removing a cover
To make the VESA fixtures accessible, remove the cover on the rear of the m onitor.
► Remove the cover as shown.
You can now mount a swivel arm or a
similar accessory in accordance with VESA
FPMPMI using a hole spacing of 100 mm.
For instructions on how to mount the swivel arm or a similar accessory, please
see the documentation for the swivel arm or similar accessory.
Connecting the device
Please observe the safety information in "Important notes", Page 7.
CE conformance and optimum picture quality are guaran teed only if
you use the data cables supplied.
► Switch off t
he monitor an d the computer.
► Disconnect the power plug from the computer.
Connecti
ng cables to the monitor
The data cables supplied have two 15-pin D-SUB connectors or two 24-pin DVI
connectors for connection to the monitor and to the computer.
Information on the computer connections and interfaces is contained in the
operating manual for the computer.
16 Fujitsu
To Next Page
Loading...
