Fujitsu ETERNUS DX S4 Series - Page 13

Safety Precautions
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
13
WARNING
Do
• Install optional products for the power synchronized unit by following the
instructions described in this manual. If an optional product is installed in any
other way, device failure or electric shock may occur.
Do Not Wet
• Do not pour or spill water on the power synchronized unit. Doing so may cause
electric shock, fire, or device failure.
Unplug
• When unplugging the power plug, do not pull on the cable, hold the plug.
Pulling the cable may expose or snap the inner wires, which can lead to
electric shock or fire.
• Use a dry cloth to remove all dust from plugs and sockets. Not doing so may
cause electric shock or fire.
• When the power synchronized unit is not used for a long period of time,
unplug all power plugs. Failure to do so may lead to fire.
CAUTION
Do Not
• When the power synchronized unit is pulled out from the rack, make sure not
to hit your head if you are operating devices under the power synchronized
unit. Not doing so may cause injury.
• Do not put your finger into the inlet/outlet. Doing so may cause injury or
device failure.
• Do not remove the cover from the power synchronized unit inlet/outlet unless
necessary. Doing so may cause device failure.
• Do not use devices such as mobile phones that emit radiation in the vicinity of
the power synchronized unit. Doing so may cause malfunction.
Do
• Before applying insecticides for pest control, turn off the power synchronized
unit and cover it with a plastic sheet. Not doing so may damage the power
synchronized unit.