Fujitsu ETERNUS DX S4 Series - Chapter 2 Installation; Package Contents Check; Table 2.1 List of Package Contents (Power Synchronized Unit); Table 2.2 List of Package Contents (AC Sensor Unit)

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
33
Chapter 2
Installation
This chapter describes the installation procedures for the power synchronized unit and the AC sensor unit.
Make sure to check "
Safety Precautions" (page 9) before installation.
2.1 Package Contents Check
Check the list of package contents in Table 2.1 and Table 2.2 to confirm that there are no missing parts.
If there are missing parts, contact your sales representative.
Table 2.1 List of package contents (power synchronized unit)
Table 2.2 List of package contents (AC sensor unit)
Package contents Quantity Note
Power synchronized unit 1 —
RS232C cable 2
1m
For ETERNUS DX/AF connection
Rack mount kit One set —
Safety Precautions 1 —
Read Me First 1 —
Package contents Quantity Note
AC sensor unit 1 —
AC sensor port connection cable 1
4m
For power synchronized unit connection
Branch connector 1 —
Rubber foot 4
This is not used when the AC sensor unit is installed in a
rack.
Rack mount kit One set —