Fujitsu ETERNUS DX S4 Series - Page 70

Chapter 5 Adding a Connecting Device
5.2 Connection Procedure When Adding an ETERNUS DX/AF
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
70
5 Connect the ETERNUS DX/AF storage systems to the power synchronized units.
An example of a connection between five or more ETERNUS DX/AF storage systems and power
synchronized units is shown below.
For details about how to connect an ETERNUS DX/AF to the power synchronized unit, refer to "4.5
Connecting to the ETERNUS DX/AF" (page 61).
End of procedure
Power synchronization starts when connection is complete. Check that power synchronization performs
normally.
Power synchronized unit#1
Power synchronized unit#0
Added ETERNUS DX/AF storage systems
Server#0
UPS unit for
Server#0
Server#1
UPS unit for
Server#1
PWC#0 PWC#1 PWC#2 PWC#3
RS232C cables
(optional)
RS232C cables
(provided with a
power synchronized unit)
ETERNUS DX/AF #4
PWC
ETERNUS DX/AF #5
PWC
ETERNUS DX/AF #6
PWC
ETERNUS DX/AF #7
PWC
ETERNUS DX/AF #0
ETERNUS DX/AF #1
ETERNUS DX/AF #2
ETERNUS DX/AF #3