Fujitsu Eternus DX500 S3 - Page 689

Appendix A Parameter List
A.1 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
689
For the factory default settings for this function, refer to "Appendix B Setup Disk Drive Patrol" (page 975).
● Disk Drive Patrol Settings
• Disk Drive Patrol
A.1.3.11 Setup Debug Mode
For details about this function, refer to "1.4.12 Setup Debug Mode" (page 62).
For the factory default settings for this function, refer to "Appendix B Setup Debug Mode" (page 975)
.
● Master Trace Level Settings
• Master Trace Level
• Level
● Trace Level by Group
• Level
Description Select whether to "Enable" or "Disable" the disk drive patrol function.
Input condition/
Display contents
• Enable
• Disable
Description Set the master trace level.
Input condition/
Display contents
• Off
Does not save a trace. Equivalent to level "0xFF".
• Standard
The firmware trace information is saved. Equivalent to level "0x06".
• Detail
All the firmware trace are saved. Equivalent to level "0x00".
• Specification
The firmware traces according to the user specified level are saved.
Description When selecting "Specification" for the master trace level, input the trace level.
Input condition/
Display contents
• 2-digit hexadecimal (0x00 - 0xFF)
Description Input the trace level for each group ID.
Input condition/
Display contents
• 2-digit hexadecimal (0x00 - 0xFF)