Fujitsu Eternus DX500 S3 - A.3.11 Set Snapshot

Appendix A Parameter List
A.3 Volume Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
814
A.3.11 Set Snapshot
For details about this function, refer to "3.19.1 Set Snapshot" (page 327).
For the factory default settings for this function, refer to "Appendix B Set Snapshot" (page 991)
.
● Snapshot Setting
• Name
• Number of Generations
Description Input the volume name for the Snapshot destination SDV.
The following names are automatically set for SDVs in proportion to the specified
number of generations.
Input "Name" + "$snap_N" (N: Number of generations between 1 - 128)
Input the name only when executing the initial Snapshot setting.
Input condition/
Display contents
Up to 16 alphanumeric characters, symbols (except "," (comma) and "?"), and spaces
Description Specify the number of Snapshot generations.
SDVs are automatically created in proportion to the specified number of generations.
The maximum number of generations for each model is as follows.
• For the ETERNUS DX100 S3
16
• For the ETERNUS DX200 S3
64 (*1) or 128 (*2)
• For the ETERNUS DX500 S3
128
• For the ETERNUS DX600 S3
256
Input condition/
Display contents
• For the ETERNUS DX100 S3
1 - 16
• For the ETERNUS DX200 S3
- 1 - 64 (*1)
- 1 - 128 (*2)
• For the ETERNUS DX500 S3
1 - 128
• For the ETERNUS DX600 S3
1 - 128
*1: The maximum number of generations after the existing controller firmware is
updated to V10L33 or later.
*2: The maximum number of generations when the ETERNUS DX is shipped from the
factory or the maximum number of generations when adding memory (in cold
mode) after the existing controller firmware is updated to V10L33 or later.