Fujitsu Eternus DX500 S3 - B.2 Volume Management

Appendix B Factory Default List
B.2 Volume Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
988
B.2 Volume Management
This section provides information on the default parameters of the following actions for volume management.
• Create Volume
• Rename Volume
• Modify Thin Provisioning Volume Threshold
• Set Allocation
• Start RAID Migration
• Modify Cache Parameters
• Set ALUA
• Set Volume QoS
• Set Snapshot
■ Create Volume
Screen Setting item Default value
New Volume Allocation Thin
NAS FS Block Size 256 KB
RAID Group/TPP Selection Automatic
Data Integrity Default
Automatic Setting Drive Type Online (*1)
RAID Level High Performance (RAID1+0) (*1)
Key Group Enable
Number of Volumes
• If the volume is not "NAS Volume"
0
• For "NAS Volumes"
1 (fixed)
Encryption by CM Off
Manual Setting (When creat-
ing Standard, SDV, or SDPV
type volumes)
Use all Largest Free Space
"Enable" checkbox
Cleared
Volume No.
"Set Value" checkbox
Cleared
Encryption by CM Off
Manual Setting (When
creating TPV or NAS type
volumes)
Volume No.
"Set Value" checkbox
Cleared
Manual Setting (When
creating WSV type volumes)
Volume Information
Use all Largest Free Space
"Enable" checkbox
Cleared
Volume No.
"Set Value" checkbox
Cleared
Wide Stripe Size Normal
Concatenation Order Automatic
Encryption by CM Off