Fujitsu Eternus DX500 S3 - Setup Debug Mode

Chapter 1 System Management
1.4 System Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
62
The main setting item is as follows.
● Disk Drive Patrol Settings
• Disk Drive Patrol
3 Click the [Set] button.
 A confirmation screen appears.
4 Click the [OK] button.
 The disk drive patrol starts.
5 Click the [Done] button to return to the [System Settings] screen.
End of procedure
1.4.12 Setup Debug Mode
This function sets the trace level to store the storage system information and the collection mode for panic
dumps when errors occur.
For details on the parameters for this function, refer to "A.1.3.11 Setup Debug Mode" (page 689)
.
For the factory default settings for this function, refer to "Appendix B Setup Debug Mode" (page 975)
.
The procedure to set the collection conditions for the storage system information is as follows:
Procedure
1 Click [Setup Debug Mode] in [Action].
If you need to change the debug mode settings, follow the Support Department instructions.
• Trace information is included in the panic dump.
• To collect a panic dump, use the [Export/Delete Panic Dump] function. Refer to "1.9.4 Export/Delete Panic
Dump" (page 158) for details.