Fujitsu Eternus DX500 S3 - Eco-Mode Management; Modify Eco-Mode General Setting

Chapter 1 System Management
1.6 Eco-mode Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
75
1.6 Eco-mode Management
This section describes Eco-mode management.
Eco-mode management provides the following functions.
• Modify Eco-mode General Setting
• Create Eco-mode Schedule
• Delete Eco-mode Schedule
• Modify Eco-mode Schedule
1.6.1 Modify Eco-mode General Setting
This function enables or disables the Eco-mode setting for the ETERNUS DX S3 series.
For details on the parameters for this function, refer to "A.1.5.1 Modify Eco-mode General Setting" (page 692)
.
For the factory default settings for this function, refer to "Appendix B Modify Eco-mode General Setting" (page
976).
The procedure to set the Eco-mode schedule for a RAID group is as follows:
Procedure
1 Click [Modify Eco-mode Setting] in [Action].
The ETERNUS DX200F does not support Eco-mode management functions.
Eco-mode is not available for the following drives:
• Hot Spares (except Dedicated Hot Spares)
• SSDs and SSD SEDs
• A drive that is in a RAID group that satisfies the following conditions:
- A RAID group where no volumes are registered
- A RAID group where SDPVs are registered
- A RAID group that is registered as an REC Disk Buffer
- A RAID group where ODX Buffer volumes are registered
To create a new Eco-mode schedule, refer to "1.6.2 Create Eco-mode Schedule" (page 76).