Fujitsu Eternus DX80 S2 - Data Migration; Storage Migration; Figure 5.23 Storage Migration

Chapter 5 Basic Functions
5.6 Data Migration
ETERNUS DX80 S2/DX90 S2 Disk storage system Overview
Copyright 2013 FUJITSU LIMITED P3AM-4812-11ENZ0
76
5.6 Data Migration
This section explains the function that migrates data from an old storage system to the ETERNUS DX Disk
storage system.
5.6.1 Storage Migration
Storage Migration is a function that migrates the volume data from an old storage system to volumes in a
new storage system without using a host in cases such as when replacing a storage system.
The source storage system and destination ETERNUS DX Disk storage system are physically connected using
cables. Data read from the target volume in the Migration Source is written to the Destination volume in the
ETERNUS DX Disk storage system.
Since Storage Migration is controlled by ETERNUS DX Disk storage system controllers, no additional software is
required.
Figure 5.23 Storage Migration
The ETERNUS DX Disk storage system firmware version must be V10L16 or later to use the Storage Migration
function.
The firmware version can be checked via ETERNUS Web GUI or ETERNUS CLI. When upgrading firmware is
required, contact your sales representative.
ETERNUS DX Disk storage system
Migration source
storage system
Storage Migration
FC