Fujitsu ETERNUS Server Connection Guide

Chapter 1 Workflow
>
ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for Windows®
10
Copyright 2010 FUJITSU LIMITED
P3AM-2922-05ENZ0
Driver Installation
Install the appropriate driver for the Fibre Channel card and Multipath Driver to be used.
Refer
- "Chapter 8 Installing Drivers" (page 22)
- Install and set up the card and driver.
• "ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for
Windows® Driver Settings for PRIMERGY/PRIMEQUEST 1000 Series"
• "ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for
Windows® Driver Settings for PRIMEQUEST 500/400 Series"
• "ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for
Windows® Driver Settings for Emulex Fibre Channel Cards"
• "ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for
Windows® Driver Settings for QLogic Fibre Channel Cards"
- Check the Fibre Channel card driver versions.
• "Server Support Matrix"
Connected Devices Check
Check the ETERNUS Disk storage system LUNs and status of the connection to the
server.
Refer
- "Chapter 10 Checking the Connected Devices" (page 27)
Operation-related Preparation
Create disk partitions and set up the cluster configuration as necessary.
Refer
- "Chapter 11 Creating the Disk Partitions" (page 29)
- "Chapter 12 Setting Up the Cluster Configuration" (page 30)

Fujitsu ETERNUS Specifications

General

Category	Storage
Brand	Fujitsu
Product Line	ETERNUS
Capacity	Varies by model
Interface	SAS, iSCSI, Fibre Channel
Management Software	ETERNUS SF