Fujitsu ETERNUS - Chapter 1 Workflow

ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) for Windows®
9
Copyright 2010 FUJITSU LIMITED
P3AM-2922-05ENZ0
Chapter 1 Workflow
This chapter describes how to connect the ETERNUS Disk storage systems to a Windows®
server.
Workflow
ETERNUSmgr Installation and ETERNUS Disk storage systems' Setup
If the ETERNUSmgr is to be used, install it and set up the ETERNUS Disk storage system.
Refer
- "Chapter 4 Installing and Setting Up ETERNUSmgr" (page 18)
- "Chapter 5 Setting Up the ETERNUS Disk Storage Systems" (page 19)
- Install ETERNUSmgr.
• "ETERNUSmgr Install Guide"
- Check ETERNUSmgr operation.
• "ETERNUSmgr User Guide"
- Set up the ETERNUS Disk storage system.
• "ETERNUS Disk storage systems Server Connection Guide (Fibre Channel)
ETERNUS Disk Storage System Settings"
Fibre Channel Switch Setup
If a Fibre Channel switch is to be used, set it up and connect it now.
Refer
- "Chapter 6 Setting the Fibre Channel Switches" (page 20)
- Set up the Fibre Channel switch.
• "ETERNUS Disk storage systems Server Connection Guide (Fibre Channel) Fibre
Channel Switch Settings"
- Check the Fibre Channel switch connection requirements.
• "Server Support Matrix for FC-SWITCH"