2.1 Turning ON/OFF the Scanner
fi-5015C Image Scanner Operator’s Guide 11
BASIC SCANNER OPERATIONS
2
3. In this screen,
• To power on/off the scanner by pressing the Power button:
⇒ select "Enable power switch".
• To power on/off the scanner by connecting or disconnecting the AC cable:
⇒ select "Disable power switch".
■ Power Save Mode
The Power Save mode keeps the scanner in a low-powered state after it has been turned ON.
If no operation is performed on the scanner for 15 minutes, the scanner automatically switches to
the Power Save mode.
In the Power Save mode, the indication of the Function Number display on the operator panel goes
out, but the green LED stays lit.
To return from the Power Save mode, perform one of the following:
• Load the document on the ADF paper chute.
• Press any button on the operator panel.
(The scanner will be turned OFF when pressing down the power button for at least two
seconds.)
• Execute a command from the scanner driver.
To Next Page
Loading...
Need help?
General