16
2.3 Loading Document on Flatbed
1. Open the document cover.
2. Place the document on the document bed (glass) with face down.
3. Position the document so that the upper-left corner of the document is aligned with
the reference mark of the document bed.
4. Close the document cover gently.
5. Scan the document.
For how to scan the document, refer to "2.4 Scanning Documents" on page.18.
■ Scanning Thick Documents with Flatbed
When scanning a thick document such as a book, please remember the following notes.
1. The document cover can be pulled out upwards.
2. The not-seated part of the document is not scanned correctly.
CAUTION
Do not look directly at the light source during the scan-
ning operation.
ATTENTION
• Do not move the document during scanning.
• Do not press or open the document cover during scanning.
To Next Page
Loading...
